Using Emp Monitor; Opening And Closing Emp Monitor - Epson PowerLite 410W User Manual

note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network On in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
note
If you want to monitor the
projector while it is in
standby mode, select
in the
Standby Mode
Extended menu, then select
. See page 62.
Network On
Monitoring the Projector Over a Network
98
■
Address 1/2/3 Setting
Choose one of the
address where you want to receive a message when a problem
occurs and select the condition under which you want to
receive a message.
4. When you're done, press
When a problem occurs, an e-mail message is sent to the specified
addresses with the subject line
information:
■ Line 1: The name of the projector where the problem has
occurred
■ Line 2: The IP address of the projector where the problem has
occurred
Line 3: Details of the problem
■

Using EMP Monitor

EMP Monitor lets you use a remote computer to manage your
projectors. It lets you easily turn the projector on or off, switch image
sources, and check its status.
Before using EMP Monitor, make sure you've installed the software
(available for Windows only) as described on page 94. The computer
you're using to monitor the projector should already be connected to
your network.

Opening and Closing EMP Monitor

To start EMP Monitor, click
EPSON Projector > EMP Monitor
If you've added the program to the Startup programs folder, it may
already be open. If so, click the icon in the system tray on the
lower-right corner of your screen to start EMP Monitor:
numbers, then enter the e-mail
Address
to exit the menu system.
Menu
EPSON Projector
or
Start > Programs
.
and the following
All Programs >
Click here to start
EMP Monitor