Monitoring the Projector Over a Network
96
Selecting Network Settings
Follow the instructions in this section to set up the projector's
network settings in the menu system.
1. Press the
button.
Menu
2. Select the
Network
3. Press
. Then use the up and down arrow buttons and the
Enter
button to set the following options:
Enter
■
Wired LAN
If your network assigns addresses automatically, turn on the
setting.
DHCP
If your network does not assign addresses automatically, turn
off
and enter the projector's
DHCP
, and
Mask
Gateway Address
To enter numbers, use the numeric buttons on the remote
control.
■
PJLink Password
Lets you enter a password for using the PJLink
control the projector.
■
Web Control Password
Lets you enter a password for accessing the projector over the
web from a computer running the EMP Monitor software.
menu.
IP Address
as needed.
,
Subnet
™
protocol to