TREADMILL ASSEMBLY STEPS:
Step 17 Rear Foot Leveling:
a) Ensure treadmill incline rack
wheels and rear feet are resting on
the floor and not on cardboard,
packaging, etc.
b) Using a 15/16 inch open
end wrench, loosen nut A on
Right Rear Foot (only side
adjustable).
c) Using a level or estimating by sight,
turn section B of foot clockwise, or
counter-clockwise, using a 7/8 inch
open end wrench to level the rear of
treadmill.
d) Tighten nut A until it is secured
against bottom of treadmill.
Note: The recommended gap between
(A) and (B) is 1/4" on a flat floor.
Step 18 Power Cord Retainer:
a) Install the power cord retainer assembly in
the order shown, but do no tighten.
b) Rotate power cord retainer down and
tighten the screw to push the retainer up
against the power cord.
Hardware Required:
1 spacer
Note: The 110V spacer is 1-3/4" long.
The 220V spacer is 1-1/4" long.
1 retainer-power cord
1 bolt M5 x 60
CHAPTER 2: ASSEMBLY GUIDE
Truefitness.com / 800.426.6570 / 636.272.7100
110V
configuration
220V
configuration
30 of 171