Table of Contents
Advertisement
CHAPTER 2: ASSEMBLY GUIDE
TREADMILL ASSEMBLY STEPS:
Step 11 Power Inlet Assembly-220V (Optional):
a) Remove any power cords that might be
attached to the unit. Note: This step can be
performed without removing the motor
cover. The power inlet assembly can safely be
pulled out about 4 inches.
b) Remove the power inlet assembly-110V
from the power panel assembly. Keep the
three screws M5 x .8 for later in this step.
c) Install the 220V power inlet assembly as
follows: Disconnect the wires one at a time
as you transfer them from the original 110V
panel to the 220V panel. Note: The 220V
panel has a green, blue, and a brown color
dot on it. The colored dots correspond to
which color cables should be installed at
those locations. Begin moving the GREEN/
YELLOW wire over to the GREEN dot. Next,
move the BLUE wire over to the BLUE dot.
Lastly, move the BROWN wire over to the
BROWN dot.
d) Secure the power inlet assembly-220V to
the power panel assembly using three screws
M5 x .8.
Hardware Required:
3 screws M5 x .8
Truefitness.com / 800.426.6570 / 636.272.7100
22 of 171
Advertisement
Table of Contents
