True TC900 Owner's Manual page 24

CHAPTER 2: ASSEMBLY GUIDE
TREADMILL ASSEMBLY STEPS:
Step 13 Motor Cover:
a) Ensure the rubber trim
rings at the base of the
pedestal arms are slid
upwards near the console
rack and then rotated to
the side so that they will
stay upwards.
b) From the treadmill
user's position, slide
the motor cover into
position over the motor
compartment. While
slightly flexing the sides
outwards, carefully lower
the motor cover into
position. Try to avoid
dislodging the rubber bolt
head caps. Next, push
the motor cover firmly
downwards to engage
the two snap action
engagement clips.
Note: If a rubber cap came out, flex the motor cover outwards at this time and reinsert the cap before installing
the side screws in the motor cover.
Truefitness.com / 800.426.6570 / 636.272.7100
24 of 171