The Default Values After Refreshing - AEI DK-2890 User Manual

THE DEFAULT VALUES AFTER REFRESHING

LOCATION
0 1 Master Code
0 2 Super User Codes
0 3 Common User Code 1
0 4 Common User Code 2
1 0 User Codes & Cards for O/P 1
2 0 User Codes & Cards for O/P 2
4 0 Visitor Codes
5 1 O/P Mode of The O/P 1
5 2 O/P Mode of The O/P 2
5 5 System Real-Time-Clock
5 6 Start & Stop Time
6 0 Personal Safety & Lock-out
7 0 User Code Entry Mode
7 1
Pacifier Tones ON-OFF Selection
7 2 O/P Operation Announcer
7 3 Status LED Standby Flashing ON-
OFF
9 0 Egress Delay & Warning
9 4 Operation Modes
NOTE:
The DAP Code 2 8 2 8 and the Refreshing Code 9 9 9 9 are fixed in the operating system program.
It can not be changed in any ways.
PARAMETERS DEFAULT FUNCTIONS & VALUES
0 0 0 0 Factory Set, Not a default value *
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Nil ----- User Program Required
Time = 5 Sec, Momentary
Time = 5 Sec, Momentary
Nil ----- User Program Required
Nil ----- User Program Required
Code = 1, 10 False Code/Card Lock-out 60 Sec
Code = 2, Manual Entry Mode
Code = 1, Pacifier Tone ON
Code = 1 Sec, Notification Beep ON
Code = 1, Flashing Enabled
Code 1 = 0, Instant, No Delay
Code 2 = 1, Momentary Contact without Warning
Code = 0 , Keypad Mode
