Table of Contents
Advertisement
OPERATION AND FUNCTIONS OF THE SUPER USER CODE
1) Operate Output 1
The operation of the Super User Code is just like a normal User Code. Simply key-in the Code with a
specific output number for the desired Output. The Super User Code can also be used to reset an
operating output timer instantly.
SUPER USER CODE
Optional Functions Controlled by Super User Code for Output 1
Apart from controlling of the output 1; the Super User Code can also be used to enable the optional
functions controlling Output 1 for user convenience or security enhancement.
Super User Code and Egress Button are excluded from any system inhibition and lockup functions;
they are valid for door open at anytime for safety.
2) Override The Door Lock Controlled by Output 1 (Keep Door Un-locked)
The Output 1 is usually for door lock control. In some situations, the door may require un-locked for
a period of time to allow door opening without User Code or EM Card for entry / exit convenience.
This function Starts / Stops in toggle with the following code entry.
SUPER USER CODE
NOTE :
The door is un-locked while the function is enabled. The "Output 1" LED (Green) turns ON.
•
Do not forget to stop this function after use because the door is un-locked. Also, the system
•
refuses the optional functions (3) & (4) while Override function comes into effect.
This feature is good for all the "Fail-safe electric locks".
•
"Fail-secure electric lock" requires power to keep in un-locked condition. It takes high current
•
all the time while the function comes into effect and may cause damage to it. This function is not
recommended for Fail-secure electric lock.
3) Pause The Scheduled Daily Inhibition for Output 1 (Temporarily Disable The Inhibition)
The scheduled inhibition can be programmed and applied to Output 1 with daily start and stop times.
It can be stopped temporarily if required; such as the staff work overtime after office hours going
into the inhibition period. This function Starts / Stops in toggle with the following code entry. It can
be done before or during the inhibition period.
SUPER USER CODE
NOTE :
• The "INHIBIT" LED (Red) is ON in inhibition and turns to Flashing while pause is into effect.
• See Programming Locations 55 & 56 for more information Daily Inhibition.
---------- Output 1 Activates or Resets
---------- The Door is Un-locked, Start / Stop in Toggle
---------- Door Lock Operation Resumes, Start / Stop in Toggle
Advertisement
Table of Contents
