Apache Labs ANDROMEDA ANAN-7000DLE MKII User Manual page 54

4. Navigate to the folder you unzipped and run HPSDRProgrammer_web.exe (it is
recommended you do this from a command prompt window so that you can watch for any
error messages and because it gives you certain instructions).
5. Open a web browser and browse to "http://localhost:8228/intro/".
6. Click "Select Interface", then select the interface you think the radio is on. If you guess
wrong it is quite possible the programmer will crash. If so, start over at step 5.
7. If there is a radio to be found it will be on the "Select HPSDR" list. Select it and click "Select".
8. Click "Program" then click "Choose File", then choose the firmware file you want to load.
9. Click "Upload", then click "Program". The erasure phase will take a little over 30 seconds. No
feedback will be seen in the command window. The programming phase will take about 7
seconds, you should see feedback in the command window.
10. Click "Quit", then click "Quit" again.
11. Re‐start THETIS to use the new firmware.
ANDROMEDA Manual Page 54 of 56