Siemens FC361 Series Technical Manual page 142

Appendix G: Default settings for panel/devices
21
142 | 151
Outputs on Output card (4M)
Items Output usage Monitor
Configurable OUT1 RT Fire
Configurable OUT2 RT Fault
Configurable OUT3 Sounder line
Configurable OUT4 Sounder line
Communication interface
Items Address Trouble
inhibite
d
ESPA 1 No
DMS 4 No
Ext. printer - -
Special panel settings
Items
MCP broken glass message
MCP cannot be disabled
Sounder outputs activation via silence/resound
button
Resound sounders on new alarm
Lamp test activation possible at access level 1
Acknowledge used as silence
Acknowledge availability at access level 1
Block ackn./reset if RT is active
RT Fire Relay, default activated (inverse driven)
RT Fire LED activated by
RT fault, default activated (inverse driven)
Technical device with panel buzzer activation
Technical Latched device with panel buzzer
activation
Synchronization between EVAC zones (max 3
devices per zone)
Internal AI operation in idle mode
Ext. Alarm Indicator global setting (connected)
Main power fault delay function
Main power delay time
Time for delay alarm (Second)
Confirm for delay alarm (Second)
creeping open
/ short
No
No
No
No
Baud rate Parity
9600 None
9600 None
9600 None
Default settings
1
Yes
No
No
Yes
Yes
No
No
No
OFF
RT Fire
ON
No
Yes
No
Normal: Off
Yes
ON
10 mins
60 s
60 s
Tone Activation
condition
(cause)
- Global alarm
- Any fault
Continuous Any fire
Continuous Any fire
Data Stop Flow
bits bits control
8 1 None
8 1 None
8 1 None
A6V10421795_en--_k