Epson Stylus Color 3000 User Manual page 16

Introduction
Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
If the power cord or plug is damaged; if liquid has entered
the printer; if the printer has been dropped or the cabinet
damaged; if the printer does not operate normally or
exhibits a distinct change in performance. Adjust only those
controls that are covered by the operating instructions.
Note the following precautions when using a printer stand with
this printer:
Use a stand that can support at least 66.0 lb (30.0 kg).
Never use a stand that tilts the printer. The printer should
always be kept level.
Position your cables so they do not interfere with paper
feeding; where possible, secure them to a leg of the printer
stand.
Even if you are familiar with other types of printers, be sure to
read through the following list of precautions before operating
your ink jet printer:
Do not put your hand inside the printer or touch the print
heads during printing.
Under normal circumstances, ink will not come out of the
cartridges. If it does get on your skin, wash it off with soap
and water. If it gets in your eyes, flush them immediately
with water.
Keep ink cartridges out of the reach of children.
Do not dismantle the ink cartridges or try to refill them.
This could result in damage to the print head.
Once you install an ink cartridge, do not remove the
cartridge except to replace it with a new one. The cartridge
may become unusable otherwise.
Install the ink cartridge immediately after you remove it
from its package. Leaving the cartridge unpacked for a long
time before use may result in reduced print quality.
8