Communication And Monitoring Device - Omnik Omniksol-2.5k-TL2-S User Manual

6.4 Communication and Monitoring Device

There are 2 RJ45 plugs in the bottom side of the Omnik inverter as the following figure:
These 2 RJ45 plugs are used for multipoint communications, that is, up to 50 Omnik
inverters can be connected one by one through these 2 plugs and the cables, the upper
computer can communicate with these inverters via a single signal cable at the same
time, and maximum length of the cable is 1000m. Through these plugs, the user can get
the data from these inverters, and can also configure parameters of them.
30
(ill. 17)
Screw up the cable gland hand-tight with the tools PV-MS
or tighten the cable gland with the tools PV-WZ-AD/GWD
and PV-SSE-AD4.
In both cases: The tightening torque must be appropriate
for the solar cables used. Typical values are between 2,5
Nm and 3 Nm.
(ill. 18)
Plug the parts of the cable coupler together until they click
in place. Check that they have engaged properly by pulling
on the cable coupler.