Communication And Monitoring Device - Omnik Omniksol-1k-TL User Manual

User Manual V4.2

6.5 Communication and Monitoring Device

There are 2 plugs in the bottom side of the Omnik inverter as the following figure:
These 2 plugs are used for multipoint communications, that is, up to 50 Omnik inverters can be
connected one by one through these 2 plugs and the cables, the upper computer can
communicate with these inverters via a single signal cable at the same time, and maximum
length of the cable is 1000m. Through these plugs, the user can get the data from these
inverters, and can also configure parameters of them.
32