Stabilizer Bar - Mitsubishi LANCER EVOLUTION-IV 1998 Workshop Manual

STABILIZER BAR

REMOVAL AND INSTALLATION
Pre-removal Operation
D
Crossmember Removal
SHOWA SHELL SEKIYU
VARIANT R-2 or equivalent
Removal steps
1. Stabilizer link
2. Stabilizer bar bracket
"AA 3. Fixture
"AA 4. Bushing
5. Stabilizer bar
Approx. 10 mm
FRONT SUSPENSION –
1
INSTALLATION SERVICE POINT
"AA FIXTURE / BUSHING INSTALLATION
Install the stabilizer bar so that the identification mark is
positioned at left. Fit the bushing so that the mark may protrude
about 10 mm from the inner end of the bushing, then secure
it with the fixture.
Stabilizer Bar
Post-installation Operation
(1) Crossmember Installation
(2) Check the Stabilizer Link Ball Joint Dust Cover for
Cracks or Damage by Pushing it with Finger.
3
39 {4.0}
39 {4.0}
2
33A-9
22 {2.2}
4
5
1
Unit: Nm {kgf@m}