Table of Contents
Advertisement
00-26
GENERAL -
PLATE TYPE LIFT
To avoid damaging the side sill garnish, put a wooden block between the side sill and a lift.
NOTE
The wooden block should be 100 mm wide and 50 mm high.
H-bar lift
Chassis-sup-
port position
(side sill)
Attachment
Section A - A
H-bar lift
Attachment
A
A
Support Locations for Lifting and Jacking
SUPPORT POSITIONS AND SUPPORT METHOD
FOR AN H-BAR LIFT
H-bar lift
Caution
When service procedures require removing the rear
suspension, fuel tank, spare tyre and rear bumper, place
additional weight on rear end of vehicle or anchor vehicle
to hoist to prevent tipping of centre of gravity changes.
When H-bar lift is used to lift up vehicles, use of metallic
attachment attached to the H-bar lift may cause damage
to the suspension arm etc. Therefore, lift up the vehicle by
the following procedure.
1. Place the vehicle on the H-bar lift (same direction).
2. Place attachments on the H-bar lift at the designated
chassis-support positions. When making the attachments,
refer to the section concerning making them.
Caution
If support is at any location other than the designated
Side sill
positions, the body or suspension might be deformed
or otherwise damaged, so care should be taken to
support only at the correct (designated) positions.
3. Raise the H-bar lift to the height at which the vehicle
H-bar lift
is slightly raised and check to be sure that the vehicle
is correctly and sufficiently secured; then raise the vehicle.
Advertisement
Table of Contents
