Fluid Level Check; Bleeding - Mitsubishi LANCER EVOLUTION-IV 1998 Workshop Manual

REAR AXLE
Filler plug
49 Nm {5.0 kgf@m}
Gear oil
Vinyl hose
– On-vehicle Service <Vehicles with AYC>
3-2 TORQUE TRANSFER MECHANISM
(1) Remove the drain plug to discharge the gear oil.
(2) Fit the drain plug and tighten it to the specified torque.
(3) Remove the filler plug and add the specified gear oil
Drain plug
49 Nm
{5.0 kgf@m}
(4) Fit the filler plug and tighten it to the specified torque.

4. FLUID LEVEL CHECK

(1) Remove the maintenance lid located in the luggage
(2) If the vehicle has been run, leave it for 5 min. or more
(3) Check that the fluid level in the oil reservoir is in the
(4) If the fluid level is lower than MIN, add the specified
(5) Reinstall the maintenance lid.

5. BLEEDING

(1) Lift up the vehicle.
(2) Remove the cap of the left bleeder screw on the torque
Bleeder
(3) Gradually turn the steering wheel clockwise from the
screws
(4) After air has been completely discharged, tighten the
(5) Repeat steps (3) and (4) two to three times until no air
(6) Perform steps (2) through (5) for the right bleeder screw.
up to the bottom end of the filler plug hole.
Specified gear oil:
MITSUBISHI GENUINE DIA QUEEN SUPER AYC
FLUID
Quantity used: 0.70
compartment.
in an ordinary temperature (10_C to 30_C) to allow the
accumulator internal pressure to drop.
NOTE
If the ambient temperature is less than 10_C or less,
allow more time to leave the vehicle to stand idle.
range between MAX and MIN.
fluid.
Specified fluid: MITSUBISHI DIA QUEEN ATF-SPII
transfer differential and connect a vinyl hose.
straight-ahead position. At this time, loosen the left bleeder
screw and check that fluid is discharged with air.
bleeder screw.
Caution
While the system is being bled of air, add fluid as
necessary to ensure that it is left in the oil reservoir
during the entire procedure.
bubbles are recognized in the fluid that comes out. Then,
tighten the bleeder screw to the specified torque.
Tightening torque: 9 Nm {0.9 kgf@m}
Note, however, that the steering wheel should be turned
counterclockwise.
)0 )0
3
dm {0.70
*0.05 *0.05
27-29
}