Lower Arm And Toe Control Arm Assemblies - Mitsubishi LANCER EVOLUTION-IV 1998 Workshop Manual

34-10
REAR SUSPENSION – REAR SUSPENSION –

LOWER ARM AND TOE CONTROL ARM ASSEMBLIES

REMOVAL AND INSTALLATION
Post-installation Operation
(1) Check the Toe Control Arm Ball Joint Dust Cover
for Cracks or Damage by Pushing it with Finger
Lower arm assembly removal steps
1. Lower arm assembly and shock
absorber connecting bolt
AA"
2. Lower arm assembly mounting bolt
"AA 3. Lower arm assembly
Mating marks
Lower Arm and Toe Control Arm Assemblies Lower Arm and Toe Control Arm Assemblies
5
6
74 – 87 {7.5 – 8.9}*
2
88 {9.0}*
1
(2) Wheel Alignment Check and Adjustment
(Refer to P.34-3.)
93 {9.5}*
4
3
AB"
AC"
Caution
The part marked with * should be first temporarily
tightened, then torqued to specification with the
vehicle on the ground in unloaded condition.
REMOVAL SERVICE POINTS
AA" LOWER ARM ASSEMBLY MOUNTING BOLT
REMOVAL
Place mating marks on the lower arm and the eccentric cam
bolt before removal.
93 {9.5}*
2
88 {9.0}*
Unit: Nm {kgf@m}
Toe control arm assembly removal
steps
4. Toe control arm and knuckle
connection
5. Toe control arm assembly mounting
bolt
6. Toe control arm assembly