Mitsubishi LANCER EVOLUTION-IV 1998 Workshop Manual page 349

MANUAL TRANSMISSION OVERHAUL –
Lock pin
Control
housing
Model
number
stamped
side
2 mm
DISASSEMBLY SERVICE POINT
AA" LOCK PIN REMOVAL
Drive the lock pin out of position from the direction shown.
Control
finger
REASSEMBLY SERVICE POINTS
"AA NEEDLE BEARING INSTALLATION
Press fit the needle bearing to the position shown in the
illustration, while making sure that the model number stamped
Needle
side is oriented in the direction shown.
bearing
"BA OIL SEAL INSTALLATION
Apply transmission oil to the oil seal lip area.
Transmission oil: DIA QUEEN MULTI-GEAR OIL 75W/85W
"CA AIR BREATHER INSTALLATION
(1) Apply a sealant to the outside circumference of the
inserting portion.
Specified sealant: THREEBOND 1501
(2) Make sure that the projecting portion is oriented in the
direction shown.
Control Housing
22B-39