Mitsubishi LANCER EVOLUTION-IV 1998 Workshop Manual page 334

22B-24
MANUAL TRANSMISSION OVERHAUL –
MD998801
Thrust plate
MD998801
Snap ring
"IA 5TH SPEED GEAR INSTALLATION
MD998812
MD998813
MD998825
"JA THRUST PLATE INSTALLATION
Select and install a thrust plate so that the input shaft 5th
Stamped
speed gear clearance will have the standard value.
surface
Standard value: 0 – 0.09 mm
Caution
Install the plate with its identification stamped surface
faced against the thrust plate stopper.
"KA THRUST PLATE STOPPER INSTALLATION
Install the thrust plate stopper by pressing the special tools
MD998812
with hand. Make sure that the stopper is not installed aslant.
MD998813
MD998825
"LA BALL BEARING INSTALLATION
MD998812
MD998819
"MASNAP RING INSTALLATION
Select and install a snap ring so that the input shaft rear
bearing clearance will have the standard value.
Standard value: 0 – 0.12 mm
Input Shaft