Table of Contents
Advertisement
122
Programming
GLIV(?) { OFF | ON | i }
The
GLIV i
Example
GLIV OFF
GLIV 0
GLIV?
PCUR(?) { i }
The
PCUR i
left edge is i=639. The cursor is visible only when the chart is paused.
Example
PCUR 319
PCUR?
CURREL(?) {OFF | ON | i}
The
CURREL i
cursor. The cursor is visible only when the chart is paused.
If the chart is paused when
located at the present cursor position (set by
is set to the most current bin location (corresponding to the right and edge of the chart);
the marker, however, will not become visible until the chart is paused.
Example
CURREL ON
CURREL 1
CURREL?
CURDISP(?) {i}
The
CURDISP i
time (i=0) or interval time (i=1).
Example
CURDISP 0
CURDISP?
CURBUG(?) {AVG | MAX | MIN | i}
The
CURBUG i
maximum (i=1) or minimum (i=2). This command is the same as pressing
horizontal scale palette.
Each pixel represents data collected over the time elapsed for one pixel of horizontal
scrolling (set by the
shows the mean, maximum, or minimum value of the data from within each pixel.
SR865A DSP Lock-in Amplifier
command pauses (i=0) or resumes (i=1) the strip chart.
Pause the strip chart
Returns the strip chart state i
command sets the strip chart cursor position i. The right edge is i=0 and the
Set the strip chart cursor to the middle of the chart
Returns the strip cursor position i
command selects relative (i=1) or absolute (i=0) mode for the strip chart
CURREL
Set cursor to relative mode
Returns the cursor relative mode state i
command sets the cursor horizontal position display mode to date and
Set cursor horizontal position to date and time mode
Returns the cursor horizontal position display mode i
command selects the strip chart cursor readout mode to mean (i=0),
GSPD
command).
transitions from 0 to 1, then the reference marker is
PCUR
). If the chart is live, then the marker
CURBUG
determines whether the cursor readout
Chapter 4
in the
Advertisement
Table of Contents
