Table of Contents
Advertisement
90
Operation
The SR865A has 4 Aux Outputs on the rear panel. Use this screen to set their levels.
Touch one of the {Out n} buttons to select an aux output, then use the keypad to enter a
value. The <Cursor> knob will also adjust the output value in this screen.
[Calc/system]
Press [Calc/system] briefly to display the calculator screen.
This is an RPN calculator where the operator follows all of its operands. For more
information, ask your friends or check the internet.
The {2
Note that the reference phase, frequency and amplitude can be copied in and out of the
calculator.
System Menu
Press and hold [Calc/system] to display the system menu. The system menu is used to set
non-measurement parameters such computer interface configurations, file names, clock
setup and more. Use the {↑} and {↓} buttons next to the category list to move up and
down through the category list (General – Files – Ethernet ...). Touch a {category} to
show its settings.
SR865A DSP Lock-in Amplifier
nd
} button switches the functions of the operator keys.
Chapter 3
Advertisement
Table of Contents
