Operation
UP
1. Power trim and tilt switch
1
UP
1. Power trim and tilt switch
3.
If you have the tilt support shaft, install
the tilt support shaft. For information on
installing the tilt support shaft, see page
29.
1. Tilt support shaft
4.
Once the outboard motor is supported
64
1
ZMU06937
ZMU06986
1
ZMU06997
with the tilt support shaft, push the "
(down) side of the power trim and tilt
switch to retract the trim rods. NOTICE:
Make sure that the trim rods retracts
completely during mooring. This pro-
tects the rods from marine growth
and corrosion, which could damage
the power trim and tilt mechanism.
[ECM00252]
1
1. Trim rods
EMU40733
Procedure for tilting down
1.
If using the tilt support shaft, fully tilt the
outboard motor up, and then remove the
tilt support shaft.
1. Tilt support shaft
2.
Push the "
" (down) side of the power
trim and tilt switch to tilt the outboard
motor down.
"
ZMU06924
1
ZMU06925