Checks After Starting Engine; Cooling Water; Warming Up Engine; Procedure For Warming Up Engine - Yamaha VF200 Owner's Manual

Operation
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, return the main switch to
" " (on), wait 10 seconds, then
crank the engine again.
EMU36510

Checks after starting engine

EMU41360

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the cooling water pilot hole shows
that the water pump is pumping water
through the cooling water passages.
TIP:
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
ECM02250
NOTICE
If water is not flowing out of the cooling
water pilot hole at all times while the en-
gine is running, overheating and serious
damage could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
58
[ECM00192]
1. Cooling water pilot hole
EMU27670
EMU41231

Procedure for warming up engine

1.
2.
EMU36531

Checks after engine warm up

EMU36541

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU40460

Stop switches

Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.

1

Warming up engine

After starting the engine, warm up the
engine until the engine speed stabilizes
at idle speed to provide maximum oper-
ating performance and acceleration.
Failure to do so will shorten engine life.
Check that the low oil pressure-alert in-
dicator remains off. NOTICE: If the low
oil pressure-alert indicator blinks af-
ter the engine starts, stop the engine.
Otherwise, serious engine damage
could occur. Consult your Yamaha
dealer.
[ECM02380]
Check that the engine stops when the
ZMU06929