Table of Contents
Advertisement
Q. Are outboard motor mounting bolts loose?
A. Tighten bolts or have serviced by a
Yamaha dealer.
Q. Is steering pivot loose or damaged?
A. Have serviced by a Yamaha dealer.
EMU29433
Temporary action in
emergency
EMU29441
Impact damage
EWM00870
WARNING
The outboard motor can be seriously
damaged by a collision while operating or
trailering. Damage could make the out-
board motor unsafe to operate.
If the outboard motor hits an object in the wa-
ter, follow the procedure below.
1.
Stop the engine immediately.
2.
Check the control system and all compo-
nents for damage. Also, check the boat
for damage.
3.
Whether damage is found or not, return
to the nearest harbor slowly and careful-
ly.
4.
Have a Yamaha dealer check the out-
board motor before operating it again.
EMU40952
Replacing fuse
EWM00631
WARNING
Substituting an incorrect fuse or a piece
of wire could allow excessive current
flow. This could cause electric system
damage and a fire hazard.
If a fuse has blown, replace the fuse accord-
ing to the following procedure.
1.
Turn the main switch to the "
position.
2.
Remove the fuse box cover.
3.
When replacing the main fuse, remove
the screws, and then remove the main
fuse. Install the spare main fuse, and
then tighten the screws.
1
2 3 4 5 6 7 8
1. Fuse box cover
2. Main fuse (60 A)
ZMU06999
3. Fuel feed pump fuse (10 A)
4. Main switch / PTT switch fuse (20 A)
5. Starter relay fuse (30 A)
6. Ignition coil / Fuel injector / Variable cam-
shaft timing / ECM (Electronic Control Module)
fuse (30 A)
7. Electric throttle valve fuse (10 A)
8. Fuel pump fuse (15 A)
9. Screw
Trouble Recovery
9
9
8
" (off)
ZMU06960
91
Advertisement
Table of Contents
