Trimming Outboard Motor; Adjusting Trim Angle - Yamaha VF200 Owner's Manual

OFF
2. Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling
the engine shut-off cord (lanyard) and re-
moving the clip from the engine shut-off
switch, then turning the main switch to the
" " (off) position.
EMU27862

Trimming outboard motor

EWM00740
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
ON
ZMU06932
1. Trim operating angle
EMU40421

Adjusting trim angle

EWM02471
WARNING
Make sure that all people are clear of

the outboard motor when adjusting the
trim angle. Body parts can be crushed
between the outboard motor and the
clamp bracket when the outboard mo-
tor is trimmed or tilted.
Use caution when trying a trim angle for

the first time. Increase speed gradually
and watch for any signs of instability or
control problems. Improper trim angle
can cause loss of control.
If the outboard motor is equipped with

a power trim and tilt switch located on
the bottom cowling, use the switch only
when the boat is at a complete stop
with the engine off. Do not adjust the
Operation
1
ZMU06933
61