Operating In Other Conditions - Yamaha VF200 Owner's Manual

Operation
while the boat is moving or engine is
on could increase the risk of falling
overboard and could distract the op-
erator, increasing the risk of collision
with another boat or an obstacle.
[EWM01850]
1
UP
1. Power trim and tilt switch
3. To return the outboard motor to the nor-
mal running position, push the "
(down) side of the power trim and tilt
switch to tilt the outboard motor down
slowly.
DN
1
1. Power trim and tilt switch
EMU41370

Operating in other conditions

Operating in salt water
After operating in saltwater, brackish water,
or water high in other minerals, flush the
cooling system with fresh water to minimize
66
corrosion and clogging of the cooling water
passages with deposits. Also, rinse the exte-
rior of the outboard motor with fresh water.
Operating in water containing mud, sand,
silt, debris, or vegetation
Mud, sand, silt, debris, and vegetation in the
water may restrict water flow into the cooling
water inlet covers or clog internal water pas-
sages. Check and clean the cooling water in-
let covers frequently when operating in these
conditions. Flush the engine with clean, fresh
water after use in these environments. Con-
sult your dealer if normal water flow can not
be restored by cleaning the cooling water in-
let covers or flushing with fresh water.
ZMU06986
"
ZMU06987