Tesla RoboStar iQ100 Manual page 75

Charging station
Remote control
BEFORE THE FIRST CLEAN
 Before you start cleaning, prepare the room in such a way that no items are left on the floor
which could prevent operation of the vacuum cleaner (heavy soiling, cables, inappropriately
positioned carpet, etc.). Move chairs and other larger items out of the way so that the robot
vacuum cleaner can reach even hard-to-reach places.
 Also move items which could damage the robot vacuum cleaner.
 The carpet must be secured in such a way that the robot cannot get on it when mopping. If a
mopping module with a water reservoir is installed in the vacuum cleaner, this may interrupt the
cleaning process or cause unwanted soaking of the carpet.
 Direct sunlight may cause reduced sensitivity of the sensors of the vacuum cleaner, please avoid
direct sunlight light.
 Black furniture may not be properly detected due to the physical nature of the infra-red sensors.
This may cause a slight impact, which will be reduced by the front bumper.
 The top cover of the vacuum cleaner is made of tempered glass. Although tempered glass is
1 Charging indicator
2 Power input
3 Charging connectors
1 On/Off (energy-saving mode)
2 Automatic cleaning
3 Cleaning along the walls
4 Start/Stop cleaning
5 Optimised cleaning
6 Mopping intensity (low)
7 Suction power (low)
8 Return to charging station
9 Clean specific location
10 Direction buttons
11 Mopping intensity (high)
12 Suction power (high)