Omron ZJ-SD Series User Manual page 130

Section 7
Specifications and Dimensions
Item
Measurement cycle
Possible settings for
number of samples to
average (*1)
Temperature
characteristics
Linear output (*2)
Bank shift input
Zero reset input
Timing input
Reset input
Function
Indicators
Power supply voltage
Power consumption
Ambient temperature
Ambient humidity
Insulation resistance
Dialectic strength
Vibration resistance
(destructive)
Shock resistance
(destructive)
Degree of protection
Connection method
Weight (packed state) Approx. 350 g
Materials
Accessories
(*1) The response speed of the linear output is calculated as the measurement period x (number of samples to
average setting + 1).
The response speed of the judgment outputs is calculated as the measurement period x (number of samples to
average setting + 1).
(*2) Current/voltage can be switched using the switch provided on the bottom of the Amplifier Unit.
(*3) Setting is possible via the monitor focus function.
ZJ-SD
116
User's Manual
1 ms
1, 2, 4, 8, 16, 32, 64, 128, 256, 512, 1024 times
Static Electricity Sensor Head: 0.01%F.S./°C
At current output: 4 to 20 mA/F.S, maximum load resistance 300 Ω
At voltage output: ±4 V, (±5 V, 1 to 5 V (*3)), output impedance 100 Ω
ON: Short-circuited with 0-V terminal or 1.5 V or less
OFF: Open (leakage current: 0.1 mA or less)
Measured value display Initialization
Present value display Teaching function
Output value display Direct threshold value setting
Setting value display Hysteresis width setting
Resolution display Scaling
ENABLE indicator Monitor focus linear output correction
Zero reset indicator Peak hold
Judgment indicator Bottom hold
ECO mode Sample hold
Display reverse Peak-to-peak hold
Display digit limit Average hold
Zero reset memory
Timers
Operation indicators: OPE1 (orange), OPE2 (green), OPE3 (yellow), 7-segment main
display (red), 7-segment sub-display (yellow), zero reset (green), enable (green)
24 VDC ±10%, Ripple (p-p) 10% max.
3.4 W or less (sensor connected) (at 24 V power supply voltage, current consumption: 140 mA max.)
Operating and storage: 0 to +50°C (with no icing or condensation)
Operating and storage: 35% to 85% (with no condensation)
20 MΩ (at 500 VDC)
1,000 VAC, 50/60 Hz for 1 min
10 to 150 Hz, 0.7-mm double amplitude, 80 min each in X, Y, and Z directions
300 m/s 3 times each in 6 directions (up/down, left/right, forward/backward)
2
IP40
Prewired (standard cable length: 2 m)
Case: PBT (polybutylene terephthalate), cover: Polycarbonate
Instruction sheet, ferrite core
ZJ-SDA11
Peak and bottom hold
Mask hold
Distance trigger
Delay hold
Delay time setting
Timing input
Clamp value setting
High-precision measurement mode
Distance correction function
Detected area correction function
Warning output function
Bank switching function