Omron ZJ-SD Series User Manual page 114

Section 6
Changing Display Scales
Executing scaling
3.
Press the UP or DOWN key.
The sub-display flashes.
4.
Use the UP and DOWN keys to display [ON].
5.
Press the ENT key to confirm the setting.
The sub-display indicates [P1SCL].
6.
Place the sensing object at the position
where the display value change is required.
Place the sensing object within the measuring range. The ENABLE indicator lights when the sensing
object is within the measuring range. Scaling is not possible if the sensing object is not within the
measuring range.
7.
Press any cursor key.
The current measured value is displayed on the main
display.
The leftmost digit of the sub-display flashes.
8.
Use the cursor keys to set the offset for the
measured value in the sub-display.
The decimal point position can be changed as follows.
9.
Press the ENT key to confirm the setting.
The decimal point flashes.
ZJ-SD
100
User's Manual
Moves from one digit to
another.
Changes the numeric value.