Commissioning, inspection, maintenance
Further details regarding the individual steps
7. Clean Lambda probe G with clean-
ing brush and vacuum cleaner.
Emptying the ash container (if required)
Empty the ash container regularly.
If "Empty ash box" is displayed on the control unit, empty the ash container imme-
diately. This applies when there are unburned pellets in the ash container.
01. Open door A.
02. Open ash door B.
40
D
C
(cont.)
8. Reassemble in reverse order.
Note
Installation position of motor F with
cables as shown.
K
A
B
G
E
03. Release handle C of ash box D
and pivot downwards.
F
H