ABB ACS2000 DFE User Manual page 156

156 ACS2000 DFE UM 3BHS360367 ZAB E01 REV. K
(If using module rails)
5.
phase module.
!
To prevent the phase module from dropping on
you, make sure the rails are slid completely under
the phase module.
(If using a module tray)
phase module. To do it:
-
-
6. Holding the phase module at the handles, pull it
out carefully.
(INU phase modules only)
7.
that are going into the cabinet from the Phase-
INT circuit board (1):
-
-
Slide the rails under the
CAUTION
Anchor the tray to the
Holding the tray at an angle, insert the hook-
shaped ends of the tray behind the two
brackets of the phase module.
Then lower the tray to engage the hooks
with the brackets.
Disconnect all cables
Auxiliary power supply cable
Two optical fibers (3)
(INU phase modules only)
8.
chain on the side of the phase module
down the end of the chain a little
pull it into the direction of the arrow
engage the chain from the mounting bracket.
(2)
1
3
2
Detach the cable
(1, 2). Pull
(3), and then
(4) to dis-
1
1
3
2
4