ABB ACS2000 DFE User Manual page 115

CHAPTER 8 – OPERATION
—
8.7 Stopping the drive
The procedure to stop the drive is described below.
Press the stop key on the CDP control panel.
The motor stops according to the preset stop
function and the drive stops modulating. While the
motor stops, the status line of the display shows
ReadyRef. The run status message blinks during
the stop sequence.
As long as the stop sequence is in progress, the
drive can always be restarted by pressing the start
key on the CDP control panel.
Just before the motor comes to a standstill, the
CDP control panel displays shortly the message
Stopping.
1 L -> 600.0 rpm
StateINU ReadyRef
MOTOR SP 300.00 rpm
POWER 20.0 kW
600.0 rpm 0
1 L ->
Stopping
StateINU
MOTOR SP 0.00 rpm
POWER
0.0 kW
When the drive has stopped modulating, the CDP
control panel displays ReadyRun.
1 L ->
StateINU
MOTOR SP
POWER
As long as the MCB has not been opened, the
motor can be started again.
115
600.0 rpm 0
ReadyRun
0.00 rpm
0.0 kW