Setting The Reset Peak Utilization - Cabletron Systems SmartSwitch 6000 User Manual

Flash Memory Installed (Read-only)
Indicates the amount of FLASH memory installed in the 6E123-50 and
6E133-49 and how much is currently available.
DRAM Installed (Read-only)
Indicates the amount of DRAM installed in the 6E123-50 and 6E133-49
and how much of it is currently available.
NVRAM Installed (Read-only)
Indicates the amount of NVRAM installed in the 6E123-50 and 6E133-49
and how much of it is currently available.
Current Switch Utilization (Read-only)
Shows how much (percentage of capacity) the 6E123-50 and 6E133-49 is
currently being used.
Peak Switch Utilization (Read-only)
Shows the peak percentage of maximum switching capacity, since last
reset.
Reset Peak Switch Utilization (Toggle)
Allows the user to reset the Peak Switch Utilization field. The switch may
be set to either YES or NO as described in
Peak Switch Utilization field to the current system traffic.

5.20.1 Setting the Reset Peak Utilization

To set the Reset Peak Utilization field to YES or NO, proceed as follows:
1. Use the arrow keys to highlight the Peak Switch Utilization field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrows keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message "SAVED OK" is displayed.
6E123-50 and 6E133-49 User's Guide
System Resources Screen
Section 5.20.1. YES resets the
5-69