Completing The Installation; Module Fiber Port Leds - Enterasys SmartSwitch 6G302-06 Installation Manual

To remove the SC connector from the GPIM, carefully pull the connector out of the port. It may
need to be moved from side-to-side gently to release the latching keys.
Figure 3-16 Module Fiber Port LEDs
If a link has not been established, refer to
persists, refer to "Getting Help"
Networks.
3.7

COMPLETING THE INSTALLATION

After installing the module and making the connections to the network, proceed as follows:
1. If the chassis is installed in a rack that has strain-relief brackets, secure the cables by running the
cables along the strain-relief bracket and tying them to the bracket using cable ties.
2. The module is now ready to be configured through Local Management. Refer to the Matrix E7
Series and SmartSwitch 6000 Series Modules Local Management User's Guide for information
on how to access and use Local Management.
Chapter 4
in About This Guide for details on contacting Enterasys
Completing the Installation
for LED troubleshooting details. If a problem
Installation 3-21