Table of Contents
Advertisement
1. Emergency Stop
button
2. Power On button
3. Reset button
4. Expose Hold
indicator
5. Tube Overheat
indicator
6. X-ray Exposure
indicator
7. Auto Positioning
button
om 5184516-100 Rev. 5
Table 4: RCIM controls
Control
Immediately powers down the system (including table,
OTS, wallstand, and x-ray tubes) and stops image expo-
sure.
Turns on the power for the entire system.
Also used in combination with the Auto Positioning button
to activate Auto Positioning functions.
Shuts down and re-starts the system for QAP or in the
event of software failure.
Lights up when there is some inhibit to taking exposures.
Click the Expose Hold button on the IUI monitor for a list
of all current inhibits.
Lights up when the tube is too hot to continue taking
exposures.
Allow the tube to cool until the The LED turns off.
Lights up when x-rays are being emitted, including tube
warm up and QAP.
Initiates automated system positioning.
Not active in this product.
Description
• To engage: Press the button.
• To release: Turn the button clockwise (indicated by
the arrows on the button) until it stops, then release.
3-6
Advertisement
Table of Contents
