GE Precision 500D Operator's Manual page 3

REV DATE
1 September 21, 2006
2 May 16, 2007
3 August 17, 2007
4 October 3, 2007
5 November 26, 2007
om 5184516-100 Rev. 5
REV HISTORY
REASON FOR CHANGE
Initial Release
Changed "power on" and "reset" instructions to indicate the
buttons being located on the RCIM instead of the IUI.
Updated model numbers in Table 7-1 an throughout docu-
ment.
Removed references to "hardcopy output" to match current
system configuration.
Changed labels on illustration of key switch on OTS con-
sole.
Removed Table 11-1, information no longer applies.
Removed RCIM from Illustration 7-2 and Table 7-1;
replaced with Operator Console. Added and updated part
numbers in Table 7-1 rows 1, 4, and 6. Removed "X-Ray
control" from row 8, JEDI Generator.
Updated Table 7-1, Items 6 and 8 to identify X-ray control
unit depending upon date of manufacture. Added model
numbers to Table 7-1 row 1(Overhead tube Collimator) and
row 4 (Precision 500D R&F Table Collimator).
Added note about radiopacity after table 7-12.
Added ifnormation on collimator lamp replacement for
model 5234954 in Chapter 8.
Added mR/mAs calibration and maintanence frequency to
table in Appendix B section 3-1.
Updated list of international keyboard options to show cur-
rent supported languages of English and German.
Added text of hardware label to Illustration 8-7.
LIST OF EFFECTIVE PAGES
PAGE NUMBER REVISION NUMBER
3-2
4-3
8-9
5
5
5