Table of Contents
Advertisement
NOTE:
om 5184516-100 Rev. 5
Manual Queries: – Miscellaneous
Clear Upon Entry: If you want to clear all the fields in the Study Information sec-
tion of the screen whenever this window is opened, select this checkbox. Other-
wise the information entered for the last query will appear by default.
Clear: This button will clear all the current data in all of the fields in the Study
Information section of the screen so different information can be entered.
Reset: This button will remove all the historical/recent listings in each of the pull–
down fields shown the Study Information section of the screen.
Set Default Field for Entry: You can set one field to be the default field for data
entry in the Study Information section of the screen by holding down the CNTRL
key on the keyboard and clicking in the desired default field box. (This is most
useful for bar code scan entries, see below).
Bar Code Scanners: Bar Code Scanners (if installed with the system) can be
used to automatically enter some form of patient data. When this screen is pre-
sented, use the bar code scanner to scan the patient ID bracelet or patient file.
The corresponding field on the screen will be filled in. See Step. 4 to continue.
The bar code data must be available on the DICOM Worklist Provider
selected.
2. Once the parameters are set as desired, select the Query button.
3. The Status bar at the bottom of the screen will show the progress of the query
results and any error messages.
4. Once the query finishes, the window becomes active again.
•
If you wish to change a parameter and re–run the query you can do so.
•
When the query has finished, select the SAVE button to save the param-
eters and close the window.
•
Select the CANCEL button if you do not want to run the query, or if you
want to close this window. If a query was run, the patient files found by
the query will remain available.
•
To stop a manual query while it is in process, you can select the CANCEL
button.
6-37
Advertisement
Table of Contents
