Advertisement
CUSTOMER RELEASE NOTES
Changes and Enhancements in 5.01.03.0007
Removed a change introduced in 5.01.03.0003 that was intended to correct an issue with persistence of port
advertised capability on combo ports. This change introduced an auto negotiation problem on Combo POE
ports where for 100Mb clients may fail to link on these ports.
Changes and Enhancements in 5.01.03.0003
Corrected an issue in the Policy MIB where the etsysPortPolicyProfileSummaryTable
(1.3.6.1.4.1.5624.1.2.6.3.3) failed to return a value for etsysPortPolicyProfileSummaryOperID.
Corrected issue that prevented multiple 802.1x Policy authentications on a single port.
Corrected an issue where receiving constant pauses frames on a port could cause Spanning Tree instability on
the switch.
Corrected a potential reset associated with one form of interface message timeout ―NIM: Timeout event‖.
Corrected an issue with GVRP that could cause a failure to properly configure egress on learned VLANs.
Corrected an issue where the port inlinepower admin state was not persistent.
Corrected an issue in the readability of output of the ―show config vlan‖ command.
Corrected an issue where ASM is unable to apply actions to ports.
Corrected an issue concerning the ―set ip protocol‖ command. If the static IP address of a switch is stored in a
configuration file, then the IP is changed to be acquired using DHCP, the original IP can now be restored using
the saved configuration file.
Corrected an issue with persistence of port advertised capability on combo ports.
Corrected an issue where high rates of multicast traffic caused pause frames to be generated on the upper
ports (25-48) of 48 port devices.
Corrected an issue with the RADIUS reauthentication timer. During an unrecognized overflow condition which
occurred approximately once every 49 days, the switch would constantly attempt to authenticate all RADIUS
supplicants. This would last for a period equal to the authentication time.
Corrected an issue in Policy that could prevent the application of a profile after a system reboot. Previously a
hardware error would be given indicating a failure to set a profile on a port.
Changes and Enhancements in 5.01.02.0007
Corrected an issue where permanent licenses were incorrectly detected as having expired.
Corrected an issue with the ―show mac port‖ command displaying output from multiple ports.
Corrected an issue where SSH IdleTimeOut was not initialized, causing a failure to timeout SSH sessions.
Corrected a potential memory corruption and reset associated with the MAC authentication process.
Corrected a potential NIM timeout event reset associated with deleting interfaces with large numbers of VLANs
(>1000).
Corrected an issue where Dynamic Egress failed if a rule to discard tagged packets was applied to the port.
Corrected a display issue where clearing default role on a port with Policy Manager, prevented the display of
user roles.
Corrected an issue in DVMRP where if a session is stopped and a new channel is selected to the same
multicast server, the stream associated with the new group was dropped.
Corrected an issue where IfSpeed and IfHighSpeed MIB objects incorrectly report port speed on 10Gig
interfaces.
Corrected an issue in the MAU-MIB ability to set dot3MauType to dot3MauType1000BaseTFD.
08/13/2008 P/N: 9038155-52
Subject to Change Without Notice
Page: 8 of 41
F0615-O
Advertisement
