Advertisement
CUSTOMER RELEASE NOTES
Changes and Enhancements in 5.01.01.0039
RIP authentication keys up to sixteen characters are now supported.
Corrected an issue with calculating reauthentication periods when the internal real time clock rolls over.
Approximately once every 50 days, for a time equal to the configured reauthentication period, all users with
reauthentication enabled will continuously attempt to authenticate.
Corrected an issue in the IPNettoMedia MIB that prevented the ability to query the host ARP cache using
SNMP.
Corrected an issue in the Bridge MIB implementation that could prevent querying learned MAC addresses
using SNMP
Corrected an issue in SNTP that prevented time synchronization to an SNTP server sending unicast traffic.
Corrected a CLI display issue with the alignment of output from the ―show inlinepower‖ command.
Corrected a CLI issue that allowed the user to edit only the first ten lines of an Access Control List.
Corrected an issue in the Access Control List implementation that prevented permit/deny rules containing the
source wildcard ―any‖ from being applied.
Corrected the potential loss of a policy mask resource that could prevent some previously acceptable policy
configurations from being applied. This issue was introduced with the forwarding of multicast addresses in the
range of 01-80-C2-00-00-00 to 01-80-C2-00-00-FF. If you need to forward these multicast addresses you must
now enable the ―set mac unreserved-flood‖ command.
Corrected an issue where an ACL would only be applied to untagged traffic.
Corrected an issue in authentication that would prevent routed frames from being forwarded.
Corrected a potential reset condition that occurred when clearing the RMON history using the ―clear rmon
history to-defaults‖ command.
Corrected an issue that occurred when processing an invalid policy role received from RADIUS. The switch
now applies the default port role, where previously the existing port role was unchanged.
Corrected a display issue where the operational status of a port would incorrectly be shown as ―up‖.
Updated the Syslog event format to comply with the RFC 3164 standard.
Added a new feature enhancement to support LACP short timers.
Corrected an issue with RMON packet capture displaying only ingress packets.
Corrected a potential memory leak associated with SNMP calls with exception conditions.
The OSPF cost command ―ip ospf cost 1‖ will no longer be automatically added when creating a loopback
interface.
Corrected an issue in the ―set policy profile‖ command that could prevent users from cutting and pasting
configurations.
Corrected an issue in setting SNTP server precedence. We now allow up to 10 entries.
Corrected a display issue with the CLI help for the ―show mac type ?‖ command.
Corrected an issue where access lists that are applied to ports that only contain a LAG do not get displayed in
the configuration.
Corrected an issue where the MIB object ifOperStatus of the host port would always return ―down‖.
Corrected an issue in the DHCP server CLI that could prevent long strings from being entered.
Corrected an issue that prevented management contact of a VRRP address on a non-virtual IP interface.
Updated the SNTP poll interval value to be configured as a power of 2, with a valid range between six and ten
as described in RFC-1305 (i.e., a poll interval set to ―6‖ would be equal to 2^6 or 64 seconds). If upgrading from
configuration which has a SNTP poll-interval set outside of the valid range of between 6 and 10, the default of 6
(2^6 = 64 seconds) will be set.
The SecureStack device will no longer send SNTP requests to SNTP servers which have been deleted from the
device configuration.
Corrected processing of packets with network directed broadcast addresses to enable support for the SNTP
Broadcast mode.
Resolved a Policy issue where PCs were not being correctly reassigned to the default policy if they were
rebooted.
08/13/2008 P/N: 9038155-52
Subject to Change Without Notice
Page: 12 of 41
F0615-O
Advertisement
