Advertisement
VLAN Classification
VLAN-to-Policy Mapping on a per Port Basis
ToS Rewrite
COS MIB – inbound rate limiting
IP Routing
Routing Protocols: RIP, OSPF, VRRP, DVMRP, IRDP,
PIM-SM
Multiple IP helper addresses per Interface (up to 6)
CoS MIB based Flood Control (broadcast, multicast,
and unknown unicast)
INSTALLATION AND CONFIGURATION NOTES:
Please refer to
http://www.enterasys.com/download/#switches
C2. In general, the SecureStack C2 product will be shipped to you pre-configured with this version of firmware. If
you would like to upgrade an existing SecureStack C2 product, please follow the TFTP download instructions that
are included in your Configuration Guide.
TFTP download instructions are also available on the Enterasys support web site at:
http://knowledgebase.enterasys.com/esupport/esupport.asp?ID=ent19703.
Soft copies of the Configuration Guide are available at no cost to the user on the Enterasys Networks web site,
http://www.enterasys.com/support/manuals. To order hard copies of the Configuration Guide, contact your
Enterasys representative.
Please refer to
http://www.enterasys.com/download/download.cgi?lib=c2
information on changes previous to the release information listed in this document.
The SecureStack C2 family of stackable switches is managed by a single IP address for a stack of up to 8
switches.
In order to download the new software to a stack of C2 switches, simply follow the instructions to upgrade a
switch with new software and then the system will automatically download the new software to all the members in
the stack controlled by that stack manager.
UPGRADING FROM PREVIOUS VERSIONS
Additional steps are required when upgrading from 1.xx.xx software to 2.xx.xx or higher software versions. These
steps will not be required in subsequent releases.
Upgrading from 1.xx.xx to 2.xx.xx
To upgrade from a 1.xx.xx version to a 2.xx.xx version follow the steps below:
1. Save the config onto the C2 stack.
2. Download the new image onto the stack without resetting the unit.
3. Load the locally stored configuration file back onto the switch/stack use the command ―configure
configs/<filename>‖.
4. When prompted that this will clear the configuration and reset the stack, type ―y‖ to continue.
The stack will reset, the current config will be cleared, the new image will start up, and the stack will automatically
program itself with the previous configuration.
If the CLI is monitored during this process, the user will see that all Diffserv commands will display error
messages stating the command is unknown. This message should be ignored and is for information only.
08/13/2008 P/N: 9038155-52
F0615-O
Existing Product Features
Ability to Set Time and Date via the MIB
Configurable Login Banner
Node/Alias Table
Clear config/clear config all will retain host IP
DHCP Server
ACLs
SMON MIB support for Port Mirroring
CPU/Memory utilization monitoring via SNMP
for the latest firmware updates to the SecureStack
Subject to Change Without Notice
CUSTOMER RELEASE NOTES
and choose the ―archive‖ link to view
Page: 4 of 41
Advertisement
