Advertisement
CUSTOMER RELEASE NOTES
Changes and Enhancements in 3.01.71
An issue was resolved with this code where in specific circumstances, a MAC authenticated user was required to
reauthorize their client every 5 minutes.
This image resolves an issue where in certain network configurations running MAC authentication, clients would
be unable to access network resources or re-authenticate.
Users who are dynamically added to a VLAN on which the host has been statically added will now have the
ability to have connectivity to the host.
User mobility now works correctly in association with MAC authentication.
Policy profile names which include spaces are now supported.
When a C2 resides in a VRRP environment, connectivity to the host will now remain resilient after a VRRP
master failover.
The device now supports the ability to be configured to transmit SNMPv3 inform messages to a remote network
monitoring application.
Clearing previously-configured SNMP access groups will no longer cause an error message to be displayed.
Disabling auto-negotiation on the SFP ports via the ifMauAutoNegAdminStatus OID is not supported and will fail.
In earlier versions of code, this action would have resulted in device resetting.
The device will no longer clear the host ARP table when pinging from the console, and will now display all
learned entries in the host ARP table when executing the switch command ―show arp‖.
In previous images, users were only allowed to create 99 rules in a policy even though 100 rules were
supported. This issue has been corrected with this release.
The C2 will now add the configured static default route to a regular RIP update when redistribution of static
routes is enabled.
Policy profiles configured for VLANs 1-4093 are now supported. If one of these profiles is matched, the traffic will
be marked appropriately and will egress out the correct VLAN.
When C2RPS-POE is connected to a SecureStack device and power is discontinued or provided on the
SecureStack C2, itself, or the backup power supply (C2RPS-POE), an enterprise MIB trap will be generated
detailing this event.
When polled, the entity MIB will display accurate descriptions of any installed MGBICs which have link.
The following Spanning Tree MIB objects are now correctly displayed in hundredths of a second:
dot1dStpMaxAge
dot1dStpHelloTime
dot1dStpHoldTime
dot1dStpForwardDelay
dot1dStpBridgeMaxAge
dot1dStpBridgeHelloTime
dot1dStpBridgeForwardDelay
Entering CTRL-S using CLI will no longer cause any affect to users who concurrently access the host using
WebView or Telnet applications.
Enabling EAPOL on LAG ports is now supported.
User-configuration of static ARP entries is now supported on SecureStack devices.
Users now have the ability to remove ports individually from a policy profile using the command ―clear policy
port‖.
Changes and Enhancements in 3.01.52
Two concurrent SSH sessions are now supported.
A potential problem has been corrected where multiple concurrent SSH sessions being heavily utilized could
cause a reset. This has been resolved.
A fix has been added that prevents excessive Linkup/Linkdown traps from causing a reset.
In previous versions, if a port was dynamically added to a VLAN and the host port was manually added to the
same VLAN, it was not possible to ping the host port from the port that had been dynamically added to that
VLAN. This has been resolved.
In previous versions, under extremely high traffic load the console could indicate a memPartAlloc memory error
message and reset. This has been resolved.
08/13/2008 P/N: 9038155-52
Subject to Change Without Notice
Page: 23 of 41
F0615-O
Advertisement
