Advertisement
CUSTOMER RELEASE NOTES
Changes and Enhancements in 5.01.05.0004
10061 Added a CLI prompt message to "set port vlan‖ informing users that setting VLAN membership for dynamic VLANs is
not supported.
10201 Corrected an issue where "set switch movemanagement" caused the policy application to fail.
10440 Corrected an issue where "[no] ip routing" command was not linked to the MIB-2 IpForwarding object.
10521 Resolved an issue which prevented DHCP clients from obtaining IP addresses from the DHCP server.
10700 Corrected an issue which prevented the "host ip" value to be properly restored from a saved configuration file.
10056 Enhanced 802.1x authentication whereby the switch continues to send periodic Unicast Request Identity frames after
the first client authenticates. Previously the switch stopped sending EAP frames after the first successful authentication.
10356 Corrected an issue where enabling port mirroring would stop traffic flow across ports that were not members of the
mirror group.
10712 / 10676 Corrected an issue where default policies were removed thus preventing 802.1x clients from authenticating.
10597 Resolved an issue in multiuserauth mode whereby an inactive user was dropped from the egress vlan list and could
no longer transmit packets out the egress vlan.
10655 Resolved an issue where client authentication failed when the management ip address was not configured.
Changes and Enhancements in 5.01.04.0001
10140 Corrected an issue with the LLDP MIB implementation that could result in the loss of SNMP
management or high CPU utilization.
10396 Corrected an issue whereby after an initial invalid RADIUS request fails, subsequent valid requests
were rejected for the same user due to caching of the initial RADIUS state attribute.
10551 Corrected an issue with displaying the correct LACP partner key when doing a ―show port lacp port
<port string> status summary‖ command.
10443 Corrected an issue with the ―clear radius server‖ command that could result in a reset.
10627/10697/10250 Corrected an issue whereby disabling dot1x on an authenticated port could affect SNMP
management or cause a reset.
10314 Corrected an issue where ports could fail to 802.1x authenticate valid users if mac locking was
enabled.
10324 Corrected an erroneous interface message timeout reset (NIM timeout event) caused during
management changes of complex interface configurations.
10554 Corrected an issue causing an SSH login to appear to hang in configurations where the motd banner
and length are set.
10501 Corrected an issue where ―show mac type self command‖ would fail to show local mac addresses.
10498 Corrected a display issue with the ―show config all spantree‖ command caused by a page break
truncating the output.
10535 Added the ability to set the PVID on a port with a VLAN learned via GVRP. A new informational
message ―INFO: PVID has been set. VLAN membership cannot be set on dynamic VLAN‖ alerts the
administrator that PVID is settable on a dynamic VLAN but VLAN membership is not configurable.
10227 Corrected issue with RADIUS server redundancy which could prevent users from authenticating via the
secondary server.
10486 Corrected an issue where ACL entries restored using a configuration file could fail to be applied.
08/13/2008 P/N: 9038155-52
Subject to Change Without Notice
Page: 7 of 41
F0615-O
Advertisement
