Using Instructions - Heinner HMFR-150SS Manual

www.heinner.com
VI. USING INSTRUCTIONS
FROTHING AND HEATING
1. Place the appliance on a flat surface.
2. Select frothing paddle according to your task. Then open the lid, insert the frothing
paddle onto the shaft on the bottom of the jar.
3. Fill the jar with the desired amount of milk and replace the lid.
Note: The max milk quantity permitted to add is 150ml (see Fig. 1), to avoid milk
overflowing after frothing. The min milk quantity permitted to add is 75ml.
Note: Please use whole milk, frozen milk (5-10℃).
4. Connect the plug into a power outlet.
5. Press the heat button once, the working indicator will light up. Then the appliance
will start to work. Once the temperature of milk has achieved the setting value,
appliance will stop working;
Note: During operation, you can stop operating by pressing the heat button once.
6. When the appliance has stopped operating, open the lid, pour out the warmed and
frothed milk to enjoy it.
Caution: Minimum 3 minutes rest time must be maintained between two continuous
cycles, otherwise, the appliance will enter self-protection state automatically after
working for 5 cycles continuously, the working indicator will flash and the switch button
will not be activated, after about 5 minutes, the appliance will enter standby state and
you can continue operating the appliance.
Note: Please clean the jar according to the section "CLEANING AND MAINTENANCE"
between two continuous cycles.
7. Always turn off the milk frother and disconnect the power supply when not use.
ONLY FROTHING SEPARATELY, WITHOUT HEATING
1. Place the appliance on a flat surface.
2. Select frothing paddle according to your task. Then open the lid, insert the frothing
paddle onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk and replace the lid.
Note: The max milk quantity permitted to add is 150ml (see Fig. 1), to avoid milk
overflowing after frothing. The min. milk quantity permitted to add is 75ml.
Note: Please use whole milk.
4. Connect the plug into a power outlet.
5. Press the froth button once, the working indicator will illuminate, the frothing
paddle will rotate for frothing milk separately, but the heating element will not
heat. And the appliance will automatically stop rotating after operating.
Note: During operation, you can stop operating by pressing the froth button once.
450-550W, 50/60Hz, 220-240V
17