Table of Contents
Advertisement
Precautions for using the battery
Improper using of the battery will cause leakage. Carefully follow these instructions.
1. Please note the batteries' polarity to avoid short circuit.
2. When the battery's voltage is insufficient which affect the use range, you should replace it with
a new battery. Remove the batteries from the remote control unit if you do not intend to use it
for a long time.
3. Do not use different types of batteries (for example Manganese and Alkaline batteries) together.
4. Do not put the battery into fire, and charge or decompose the battery.
5. Please dispose batteries abide by relevant environmental protection regulation.
2.7 Using the remote control
Use the remote control by pointing it towards the remote sensor. Items between the remote
„
„
control and the remote sensor could block normal operation.
Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote
„
„
control, also do not put the remote control in a high humidity place.
Do not place the remote control under direct sunlight which will cause deformation of the unit
„
„
by heat.
When the remote sensor is under direct sunlight or strong lighting, the remote control will not
„
„
work. If so, please change the lighting or TV's position, or operate the remote control closer to
the remote sensor.
3.0 FIRST TIME INSTALLATION
After all connections have been properly made, switch on your TV. The language selection will appear on
screen. Use pq t u to select the OSD Language of your preference. Confirm with OK on your remote
control.
The next screen appears with the Mode Selection to select Home Mode or Shop Mode. Press OK and t u
to confirm.
Then the next screen appears with the tuner selection. Choose the one you like to use.
Scan type
3.1 DVB-S/S2 installation
Satellite Setting
First select the region where you are using the TV. This important to set time zone correct. Use the
t upq and confirm with OK.
Press pq to highlight the satellite your dish is aimed at. Confirm with OK to mark the satellite. Use
the t upq buttons to change settings for your satellite installation for each specific satellite. The
signal quality bar on the bottom of the screen allows you to fine tune the alignment of your antenna for
optimum reception. Adjust your antenna for maximum possible signal quality. When the signal cannot
be improved anymore, fix the dish on this position and press the BLUE Scan button to continue.
Channel Search
Press pq t u to highlight the options of choice and press OK to start the channel search.
Scan Mode
8
Select which input source you want to use: DVB-S to receive satellite
broadcasts (and if you are equipped with a satellite dish), DVB-T to receive
terrestrial broadcasts or DVB-C to receive cable broadcasts.
Choose between Default (recommended), Blind Scan, Network and Preset
Channel List.*
Advertisement
Table of Contents
