Viessmann Vitodens 333 Service Instructions Manual page 75

Checking and acknowledging faults
Constant temperature control unit
Display Const.
fault code
0F X
10 X
18 X
20 X
28 X
Note
The fault can be acknowledged
with d. The fault message in the dis-
play will be hidden, but red fault indi-
cator U continues to flash. A new fault
message will be displayed if an
acknowledged fault is not removed by
the following morning.
Calling up acknowledged fault mes-
sages
Press d for approx. 2 s; select the
acknowledged fault with a or b.
Weat- System
h. character-
comp. istics
X Control
mode
X Controls
according
to 0 °C out-
side tem-
perature
X
X Controls
without
flow tem-
perature
sensor
(low loss
header)
X
Troubleshooting
(cont.)
Cause Remedy
Maintenance Carry out
maintenance.
Set code 24:0
after mainte-
nance
Outside tempera- Check out-
ture sensor shorted side tempera-
out ture sensor
(see page 83)
Outside tempera-
ture sensor lead
break
System flow tem- Check low
perature sensor loss header
shorted out sensor (see
page 84)
System flow tem-
perature sensor
lead break
75