Installation - Kinetico 1 Way Tap - Kinetico Kube Installation Instructions Manual

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10
Installation:
Kinetico 1 way tap
TAP BODY
RUBBER INSERT
TAP THREAD
RUBBER WASHER
METAL WASHER
STAR WASHER
NUT WASHER
TAP ADAPTOR
12
Kube Drinking Water Filter
Installation Instructions
WORKTOP
STEP 1
Drill the hole
Drill a 12mm ø hole in the appropriate location.
STEP 2
Fix the tap
Slide the rubber insert over the thread and place
neatly inside the recess under the body of the
tap. Insert the tap through the worktop. Slide
on the rubber washer, metal washer, star washer
and nut. Tighten the fixings and ensure the tap is
in the correct position before final tightening.
STEP 3
Attach the tap adaptor
Screw tap adaptor firmly onto the thread to
ensure the rubber seal is water tight.
STEP 4
Connect the outlet tubing
Push the cut length of tubing all the way into
the tap adaptor. Pull back to check it is secure.
STEP 5
Flush the system
To complete the installation process, turn the
tap and flush the system for 5 minutes.
Visit: kubewater.co.uk