Connecting Kube - Kinetico Kube Installation Instructions Manual

Connecting Kube

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10
STEP 1
Check the clearance
Clean out the area under your sink and ensure
that there is enough room for your Kube
Drinking Water System.
Check that the cold water supply, the proposed
location of the system and the location of the
drinking water tap requires no more than 1.5m
of the supplied ¼" pipe.
08
Kube Drinking Water Filter
Installation Instructions
STEP 2
Shut off the water!
Isolate the supply to your cold water tap. Open
the tap and drain any residual water to ensure it
is fully isolated.
STEP 3
Attach the saddle valve
RUBBER
GROMMET
BACK FRONT SCREWS
PLATE PLATE
Locate the 15mm ø copper cold water supply
pipe to your kitchen tap.
Select a suitable position to attach the saddle
valve, down stream of the isolation point.
Remove the screws and back plate from the
1.55
saddle valve. Place the back plate on the back
of the 15mm pipework and place the front plate
(rubber grommet facing inwards) opposite.
Using the two screws, bring the plates together,
taking care to secure firmly. Do not over tighten
and crush the copper pipe.
ON/OFF
HANDLE
BLADE
LOCKING
NUT
Visit: kubewater.co.uk