Parameters Setting; Setting Language - Growatt 10000TL3-S Installation & Operation Manual

6.3.5 Data checking and parameters setting
Cycle display
If you do not knock the enclosure lid, LCD display following information cycle by
cycle. Refer Fig 6.3.3.
Fig 6.3.3 Cycle display

Parameters setting

Fig 6.3.4 is the setting information. Single knock, the Text will display the setting.
Double knock, the Text will display"input123: 000". Single knock to go back Setting
page. Double knock the enclosure lid ready to input password. Single knock to
change value of first, double knock enter into next position. Konck three times when
the bit was "123", it will go into Setting options.
Setting
Double
Input Word:123
000
Double
Input Word:123
000
Once
Input Word:123
100
Double
Input Word:123
100
Once
Input Word:123
110
33
AC VA/Watt:
VA W
Etoday:
50 .2 Kwh
Eall:
2000 Kwh
Input Word:123
120
Double
Input Word:123
120
Once
Input Word:123
121
Once
Input Word:123
122
Once
Input Word:123
123
Three
Input OK
Set Com Address
001
Once
Set Language
Once
AC V Control :
Disable/Enable
Once
Set Date/Time
Three
Setting
Fig 6.3.4 setting second level menu and its sub-menus

Setting language

To change inverter's displaying language, please select Setting->Set language, then
LCD screen will display current language type, single knock to change current
language, knock three times will save changes and displays "Set OK! Current
Language English" Refer Fig 6.3.5. Knock four times to exit setting.
Set Language
Once
Three
Fig 6.3.5 setting language
Please note in order to prevent disoperation, system language won't be change in
second level menu "Set language", but it will be only if user saves save the choice by
knock three times and LCD displays "Set OK!"
Setting inverter's COM address
When communicating with monitoring software or device, the software or device
may regard inverter's COM address as communication address (Also may use
inverter's serial number as communication address).The COM address could be
assigned. The second level menu "Set COM Addr" of setting is to set inverter's COM
address.
Double
Set Language
English
Double
AC V Control :
Disable
Double
Date：2012/04/05
Time： 14:20:38
Set Language
English
Set Language
xxxx
Set OK
34