Craftex CX100 User Manual page 10

Figure-8 Attaching the table tilt bracket
Once the table is in the correct position,
tighten the table lock knobs under the table
and the tilt lock knob.
Install the table insert at the center of the
table and the table pin into the table slot as
shown in figure-9
Figure-9 Installing table insert and table pin
Take the rail bracket (smaller) and attach it
to the table using cap screws provided. See
figure-10
10
Figure-10 Rear rail bracket attached
Now, attach the rear rail to the brackets
using the knobs provided. See figure-11
Figure-11 Rear fence rail attached
Take the rail brackets (bigger) for the front
fence rail and attach it to the table using the
cap screws provided.
Place the front fence rail on the brackets
and insert the knobs through the hole on
each bracket and thread the T-nuts onto the
ends of the knobs a couple of turns to
tighten the fence rail in place. See figure-12