Table of Contents
Advertisement
Figure-12 Front fence rail installed
Now take the fence and pull its handle up
(in the unlocked position). Place the fence
on the front fence rail and slide it against
the blade.
Use a pencil to mark the fence rail where
the fence scale indicator on the right hand
side is pointing (there is a gap just behind
the indicator plate where you can mark the
rail). This mark will indicate where to align
the 0" mark when install the scale.
Now, remove the fence from the rail and
install the adhesive backed scale on the
front fence rail.
Figure-13 Adhesive backed scale attached
to the front rail
Once you have attached the adhesive
backed scale to the rail, place and fence on
the rail and tighten it in place by pushing
down the handle. See figure-14
Figure-14 Fence installed on the rails
Attach the miter gauge holder and the fence
holder to the back of the saw using screws
and washers provided see figure-15
Figure-15 Miter gauge holder and fence
holder installed
11
Advertisement
Table of Contents
