Figure - Keysight Technologies N9040B UXA Manual

Measurement Related Tasks and Concepts
Setting the Signal Analyzer to Make a Measurement
Table 3-2
Step
Ed it Meas Table
4. Press
which you wish to enter data.
An ENR Table appears with a table editing and
navigation menu on the left side. See the following

figure.

To clear an existing table, press
Figure 3-5
Serial #
5. (Optional) Press
serial number using the on screen keyboard or an
external USB keyboard, and press
Model ID
6. (Optional) Press
model number using the on screen keyboard or an
external USB keyboard, and press
7. Press Go To Row to move the highlight to the
Frequency/ENR column. Enter the values in the table
using the numeric keys and terminate it using the
unit menu keys.
N9069C Noise Figure Measurement Guide
to access the ENR table for
Clear Table
ENR Table
, enter the noise source
Done
.
, enter the noise source
Done
.
Notes
To enter common measurement and calibration
ENR data, press
Cal On
to . The measurement table data is
automatically used for the calibration data.
To enter either measurement ENR data or
calibration ENR data, make sure that
.
Table Data for Cal
select your table by pressing either
Cal Table
or .
You can insert the frequencies into the ENR
Table entry in any order, as the analyzer
automatically sorts the frequency list into
ascending order.
Use Meas Table Data for
Use Meas
Off
is set to , and then
Meas Table
67